Hello Keeping It Simple Readers! Happy Black Friday. Today I’m going to show you how to let down hems when you don’t quite have enough fabric.
You’ll need:
- A seam ripper
- Twill tape, grosgrain ribbon or bias tape
This is a pair of pants that I made Tater last year. The boy has grown over an inch taller, but his waist has gotten smaller! So the pants still fit him, but they’re high-water now.
Start by using your seam ripper to take out the existing hem, and iron.
I had 1 1/2″ below the hem. I needed to let these pants down at least an inch. There was no way I’d be able to make a tiny, 1/4″ hem on this wide wale corduroy.
So instead, cut a piece of bias tape, grosgrain ribbon, or in this case I used 5/8″ twill tape twice the width of your pants leg plus 1 inch. Sew this into a loop, using the extra 1″ to make 1/2″ seam allowance. Then stitch it right sides together around the bottom of you pant leg, using the smallest seam allowance you can. In this case I used 1/4″.
Turn your pants inside out, and press the twill tape to the inside. This will cover the raw edge of your pants. Stitch in place.
And now on the outside you have a normal looking hem. In my case I managed to let these pants down 1 1/4″, which will hopefully last Tater until 2013. Only 6 weeks left to go, we’ll see.
silvia guadalupe alzate cruz
me da gusto encontrar su pagina me va ayudar mucho yo vivo en mexicali baja california es una ciudad chica pero muy bonita dentro de un desierto aqui soy yo bueno gracias por aceptarme